<address id="rb75h"></address>

      <sub id="rb75h"></sub>

            <sub id="rb75h"></sub>

            欢迎访问温州市旭日印刷机械有限公司官网!

            搜索
            您当前所在位置:网站首页 > 常见问题 > 切角机常见问题
            公司产品远销国内外,在市场上有较高的信誉与知名度
            PJQ-100型切角机使用说明

            发布时间:2019-10-21

            来源:温州市旭日印刷机械有限公司

            浏览次数:94

              注意Δ:偏心轮一定要旋转到最高点切角刀才会动。

              选好切角刀,用手扳偏心轮(图(2)中3),调整好切角刀的与圆角铜垫的位置,将被切物置于工作台上,与两小侧板靠齐,尖角与裁刀“R”中心对正,然后扳下手柄或踏板,当偏心轮开始运动后,再松开手柄或踏板。这时切角刀完成一个裁切循环后停于最高点。

              如踩住踏板、或扳手柄不放时,切刀将会连续裁切。用手扳动偏心轮调整切角刀上下行程时,应将切刀扳回到最高点,使连杆(图(2)中2)垂直于工作台位置。否则,当扳下手柄(图(2)中14)或踩下踏板(图(2)中19)时偏心轮(图(2)中3)将不会转动即切角刀不能下切。

              Note Δ: The eccentric wheel must be rotated to the highest point before the cutter moves.

              Select the cutting knife, use the hand to pull the center wheel(Figure 3), adjust the position of the cutting knife and the round corner copper pad, place the cut object on the work table, and align with the two small side panels. The sharp corner faces the center of the cutter "R" and then pulls the handle or pedal. When the eccentric wheel starts to move, the handle or pedal is released. At this time, the cutter completes a cutting cycle and stops at the highest point.

              If you step on the pedal, or when the wrench handle is not put, the cutter will cut continuously. When the eccentric wheel is used to adjust the angle cutter's up and down stroke, the cutter shall be pulled back to the highest point so that the connecting rod(2 in Figure(2)) is perpendicular to the table position. Otherwise, the eccentric wheel(3 in Figure(2)) will not rotate when the handle is pulled(14 in Figure(2)) or the pedal is stepped down(19 in Figure(2)), that is, the cutter can not cut down.

            我是分类列表
              问题详情
              摇钱树捕鱼游戏平台 27| 538| 273| 929| 836| 993| 874| 913| 321| 912| 938| 57| 333| 964| 83| 675| 544| 768| 624| 769| 704| 363| 311| 759| 734| 867| 500| 554| 516| 202| 677| 87| 457| 170| 908| 818| 505| 402| 63| 145| 897| 624|